Swimming Pool Pump Maintenance

Owning a swimming pool simply means having quite the responsibility to keep it clean as always. As time goes by, your pool becomes filthier and unsafe for anyone to use for swimming. For some, one of the hardest to tackle is on swimming pool pump maintenance. Here are some techniques that will make it easier for anyone to clean their swimming pool, especially the pump.

So, how do you know which type of heater is right? Heaters all function in different ways, which means they each have there own individual list of pros and cons. To figure out which is best for you, you really do need to know specifically what your needs and desires are. In general there are three types that work for most people, the electric, gas, and solar. A certified Phoenix Pool Repair Service Specialist in the area will always be the sure way to get help at a drop of a dime.

If you have only a pool, consider getting a pump closer to the minimum size needed. However, if you have a pool and spa combination, you should get a pump closer to the high end of your range.

The pool hasn’t been used in awhile, the weather has been warm but not hot. So what do you do? Here are 7 easy troubleshooting tips to help determine if your salt chlorine generator is the problem.

Note that your Lakewood Ranch Pool Repairs should be kept free of dirt and also located where it can be protected from flooding during heavy rain (most warranties don’t cover you for flood damage). Try and keep all debris clear of drains and skimmers as clogged areas make your pump work harder.

If your leak problem isn’t from any of your pipes, unfortunately, you probably have a shell leak. An above ground pool shell leak is much easier to contend with than an inground swimming pool shell leak. With an above ground pool, you just have to find a hole where the water is coming from and repair it. It’s a lot trickier when you own an inground swimming pool. You’re going to have to try and examine the shell from inside the pool, or by searching the surrounding areas of the shell.

Robotic cleaners operate on low voltage usually 12 volts. They feature onboard filters that can collect even the finest debris. Many models flow a fair amount of water so you can reduce the amount of time your main pump runs. Even though they cost the most, they can save you quite a bit on energy, eventually saving you money. These are by far the most complex units, therefore they are the most expensive to repair.